![]() Re-upload the certificate to restore HTTPS inspection functionality. This error may occur when the security appliance has been factory reset. HTTPS inspection certificate error occurs.Once the client begins sending data through the MX and responding to ARP requests, it will again be marked as connected. If the MX does not receive an ARP reply from the client after approximately 35 seconds, it considers the client to be disconnected. Sends an email if select clients connect or disconnect from the LAN, as observed by the MX. The MX sends an ARP request to the client approximately every ten seconds to monitor its connectivity status. Clients connect or disconnect from the LAN.This alert will be triggered when a file previously downloaded on your network is determined to be malicious in retrospect. This alert will be triggered when a malicious file download is blocked. Sends an email if the primary MX of a high-availability pair fails over to the spare, or vice versa.įor more information, please refer to our documentation regarding Troubleshooting MX Warm Spare. This can occur if a DHCP relay server is configured on a VLAN where the MX is configured to respond to DHCP.įor more information, please refer to our documentation regarding DHCP configuration in the dashboard. Sends an email if the MX observes multiple MAC addresses responding to DHCP Discover or DHCP Request messages. Sends an email if the appliance establishes or loses its connection to the cellular network. For a common example, please refer to our documentation regarding IP Conflict Events Triggered by iOS Devices. Note: Due to the nature of certain device types, this event may occur as a result of normal network behavior. ![]() Sends an email if the MX has observed traffic from multiple MAC addresses using the same IP address. Indicates that the MX has run out of available IPs in one or more of its configured DHCP scopes and is unable to provide an IP address to a requesting client. In such situations, it's recommended to use the cellular connection state alerts. Note: It is not recommended to configure this alert if you are running an appliance with only a cellular uplink, as you may see false alerts about failing over to a cellular uplink if the node reboots or experiences an issue with connectivity. Sends an email if a gateway AP loses its link to the network and comes online as a repeater.įor more information on this behavior, please refer to our documentation regarding Gateway AP Switches to RepeaterĪdditional alerts can be configured to maintain visibility on wireless Bluetooth® clients:ĭetected devices will be displayed in the Wireless > Monitor > Bluetooth clients page. The name of the Bluetooth® client can also be edited for easier tracking. Email alerts can be enabled to trigger when the device becomes visible by the access point and when the device is no longer visible. Sends an email if any repeater AP is unreachable from the dashboard for the configured number of minutes. A repeater goes offline for (x) minutes.Please note that the AP may still be functioning, this only indicates that it is unable to contact the dashboard. Sends an email if any gateway AP is unreachable from the dashboard for the configured number of minutes. Alerts can be configured for the following MR access point events:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |